Raspberry Pi Servo Driver HAT (B) , 16-Channel, 12-bit, I2C Interface

Description

Note: Raspberry Pi and servos are NOT included.
Servo Driver HAT (B) for Raspberry Pi, 16-Channel, 12-bit, I2C Interface, Right Angle Pinheader
Overview
Needless to say, the Raspberry Pi is powerful enough in most cases, yet it's not that good at providing precise PWM output. You may have tried to control a robotic arm or a hexapod walker by using the Pi, but finally get frustrated due to the limited number of PWM outputs and the jittering servo. Now you get a new option to bring your ideas to life, we prepare this useful Servo Driver HAT for you.
Features
Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano
I2C controlled, using only 2 pins
Up to 16-Channel servo/PWM outputs, 12-bit resolution for each channel (4096 scales)
Integrates 5V regulator, up to 3A output current, can be powered from battery through VIN terminal
Standard servo interface, supports common used servo such as SG90, MG90S, MG996R, etc.
Reserved I2C control pins, allows to work with other control boards
Comes with development resources and manual (examples in python like Bluetooth/WiFi remote control)
Specifications
Power supply: 5V (Pi connector)
OR
6V~12V (VIN terminal)
Servo voltage: 5V
Logic voltage: 3.3V
Driver: PCA9685
Control interface: I2C
Dimension: 65mm x 30mm
Mounting hole size: 3.0mm
Supported Servo
This HAT can be used to drive servos such as:
SG90 Servo
MG90S Servo
MG996R Servo
Package Contains
Note: Raspberry Pi and servos are NOT included.
Servo Driver HAT (B) x1
RPi screws pack (2pcs) x1